Hanafy Remover & Activator set
The perfect Duo ( INSTRUCTION LEAFLET GIVEN WITH PURCHASE )
Activator for tattoo removal, 15 ml
Composition: Aqua, Glycerin, Sodium Chloride
Method of application:
1 option. Mix the Activator withHanafy® mineral remover in a 1:1 ratio in a disposable sterile container. Apply the resulting mixture during the last pass with light stroke movements similar to shadow shading on the eyebrows.
Option 2. Apply the Activator in the form of a mask to the surface of the skin after finishing using the Hanafy® remover. Effective when applied to the surface of the skin due to the additional osmotic extraction on the skin loosened by the remover.
Economical consumption due to the concentrated form
Effectively removes pigment and does not dry out the skin
Synergy with Hanafy® mineral remover
Compatible with any type of remover.
Precautions :
Avoid contact with eyes. When working with remover in close proximity to your eyes, take maximum precautions by using barrier drops and eye protection! In case of contact, rinse thoroughly with water. For external use only.
Store out of reach of children at temperatures from +5 to +25 ℃ and away from direct sunlight.
Remover No. 1 HANAFY
Composition : magnesium oxide, zinc oxide, water, glycerin, isopropanol.
Description:
Mineral remover with alkaline pH (7.7). White opaque liquid requiring thorough mixing and shaking before use.
In case of excessive thickening, dilution is allowed using Thinner from Hanafy.
Instructions:
You should work with a 3 RL needle, in short, dense strokes, evenly passing all the areas necessary for removal.
To achieve results, make two full passes over the entire area to be removed.
Only preliminary anesthesia is used; secondary anesthesia is not used during the work.
After each pass, leave the remover on the skin for 3-5 minutes, then gently wipe with chlorhexidine.
After the second pass, you can use a salt activator to enhance the result - either applying it as a mask to the treated area for 5 minutes, or diluting the remover 1 to 1 and making the third pass with lighter movements, as when spraying permanent makeup.
Care after the procedure:
1 day - do not touch.
Starting from the second day, lubricate twice a day with Bepanten or Depanthenol.
The remaining restrictions are the same as for PM (do not soak, do not steam, do not sunbathe, do not subject to mechanical damage).
Repeated procedure - no earlier than after 6 weeks.
